Talk to us for advice on the right lifts for your workshop

Arrange a consultation with a workshop expert

Commercial Equipment

Automotive lifts to suit every type of workshop

Being a smart lift user starts and ends with being a safe lift user. Because the Automotive Lift Institute (ALI) is focused on car lift safety, we’ve put together these guidelines for staying safe while using a vehicle lift. Whether you’re working with a two-post lift, four-post lift or mobile column lift, surface-mounted or inground model, make lift safety a habit and always follow these best practices.

  1. Know your lift. Start every shift with a lift walk around and get to know your lift well enough that you recognize if it shows any signs of needing service.
  2. Choose the right lift and accessories for the job. Consider the lift’s rated load capacity, clearances and ability to reach the vehicle manufacturer-recommended lifting points.
  3. Get lift operator training. Training on how to properly use the lift you are using is crucial to safe lifting.
  4. Lift it right. Don’t start lifting until you determine the vehicle’s center of gravity and OEM-recommended lifting points.
  5. Keep lift safety front and center. Post lift safety tips to avoid complacency.

Get Lift Operation Training

You probably already know the basics of how to use a car lift. However, not all lifts are the same. Training on how to properly use your lift is crucial to safe lifting. Be sure you’ve been trained and are familiar with the manufacturer’s instructions for a lift before you use it, especially if you’re using a new or different model than you’re used to. Review all lift safety materials, including the warning labels. Always follow the lift manufacturer’s instructions on how to operate the lift, including any safety features.

Training should be based on the lift manufacturer-provided instructions and warning labels, as well as the ALI publications Quick Reference Guide, Vehicle Lifting Points for Frame-Engaging Lifts, Lifting It Right, Safety Tips and the ANSI/ALI ALOIM (current edition) Standard for Automotive Lifts “Safety Requirements for Operation, Inspection and Maintenance.” Training should be documented – proof may be required during health and safety or insurance inspections.

Lift It Right

The overwhelming reasons vehicles fall from lifts are because technicians miscalculate the center of gravity, don’t spot vehicles properly or fail to chock the wheels.

Before you a lift a vehicle, you need to know where its center of gravity is. If you’re using a frame-engaging lift like a two-post lift or an axle-engaging lift like some inground lifts, you also need to check the vehicle manufacturer’s recommended lifting points. These are the points identified by the vehicle OEM as the appropriate place for the lift to contact the vehicle.

When spotting the vehicle on the lift, use any devices supplied by the lift manufacturer to help properly position the car, truck or van for lifting. Once the vehicle is in position, turn it off, close all doors and make sure no one is in the bay. If using a drive-on lift, put the vehicle in park or in gear and chock the tires.

For frame-engaging and pad lifts like two-post lifts, once the vehicle is properly spotted, raise the lift until the adapters or other supports just contact the vehicle. Stop to make sure all adapters are securely contacting the vehicle’s recommended lifting points. Then raise the vehicle again until the tires clear the floor. Shake the vehicle moderately to confirm stability. Visually check all the lifting points again.

Once the vehicle is confirmed to be stable, raise it to the desired working height and then lower the load onto the lift’s load-holding device (also known as a lock or latch). Visually check the contact points once more to make sure each adapter is securely in position before going under the vehicle.

Whenever you’re using a lift, stay at the controls throughout the lifting and lowering process. Never block, override or disable the controls, features or safety devices. What may save you a few seconds could cause a serious accident. Remember, your safety is riding on it.

ALI’s exclusive online training course Lifting It Right explains the right way to lift a vehicle without causing injury or property damage. It provides more detail on spotting and lifting a vehicle. It also covers additional topics like preparing the service bay, maintaining load stability, lowering the lift and lift maintenance.

Contact Me

Your email address will not be published. Required fields are marked *